Auto-Sell on Big Buy

Progressive automatic selling triggered by a large on-chain buy detected on your token. You define 3 tiers — the system executes.

How it works

The system monitors all buys on the tokens where you have an open position. When a wallet buys big (above a threshold you define in SOL), the corresponding tier triggers an automatic sale of part of your position.

Each tier triggers only once per token. Once L1 fired, it does not trigger again — L2 takes over on the next bigger big buy.

Configuration

For each rugger, in Sell Config → Auto-Sell on Big Buy, configure up to 3 tiers:


Level 1: 2.5–3 SOL buy → Sell 50%
Level 2: 4–10 SOL buy → Sell 100%
Level 3: 10–25 SOL buy → Sell 100%

Each tier requires :

SOL range — minimum and maximum amount of the detected buy to trigger this tier
% to sell — how much of your position is liquidated

The ranges must not overlap — each detected buy can only activate one tier.

Use case

On PumpFun, big buys often signal one of these two things:

A whale entering (bullish — you can scale out a bit to secure profits)
An insider pumping before their exit (bearish — you get out completely)

With 3 configured tiers, you play both scenarios:

Small buy (L1) → small scale out, you keep the position
Big buy (L2 / L3) → full exit before the whale dumps

💡 Recommended setup

L1 wide (50% on 2–3 SOL) + L2 strict (100% on 4+ SOL) + L3 catch-all (100% on 10+ SOL)

You secure your initial on medium buys and fully exit on the very large ones. It’s one of the most profitable edges on PumpFun for scaling profits without manual timing.

📈 Sell Config — classic TP/SL
⚡ Front Run Sell — exit on dev dump pattern
📊 Positions — view of your open positions