Skip to Content
RuggersAdd a Rugger

Add a Rugger

A rugger is a wallet address that the bot monitors for you. It can be:

  • The address of a developer who creates tokens (sniping)
  • The address of a trader whose buys you want to copy (copy trading)

How to add a rugger

  1. From the main menu, tap 🎯 Ruggers
  2. Tap ➕ Add Rugger
  3. Paste the wallet address into the chat
  4. The bot creates the rugger with no settings — it is “bare”
  5. Tap the rugger to configure it (tracking, buy, sell, protection)

💡 Tip : If you have saved Presets, apply one directly after adding to save time.

30 slots per wallet

Each wallet can monitor up to 30 addresses simultaneously. The counter at the top of the Ruggers page shows the number of addresses used out of the maximum allowed (e.g., 12/30).

When you have many ruggers, the list is paginated so the menu stays readable.

The ruggers list

On the Ruggers page, each monitored address is displayed with:

  • The name of the rugger (or the truncated address if you haven’t renamed it)
  • The tracking mode active (New Tokens, Track Buys, etc.)
  • The status ON or OFF

Global Toggles

Above the Add/Remove buttons, you will find the global toggles :

  • 🟢 Global Auto-Buy ON/OFF — Enables or disables auto-buy for ALL your ruggers at once
  • 🟢 Global Auto-Sell ON/OFF — Enables or disables auto-sell for ALL your ruggers at once

Useful for turning everything off in the evening and back on in the morning, or for quickly stopping all bot activity.

Interact with an existing rugger

Tap a rugger in the list to open its configuration page. This is where you can change all its settings.

Delete a rugger

From the Ruggers page, tap 🗑 Remove then select the address to remove from monitoring.

Rename a rugger

From a rugger’s configuration, tap ✏️ Rename to give it a custom name. This is highly recommended when you have several addresses — “RugKing_42” is clearer than “7xKp…3mNf”.

Navigate the BotRugger Config